This training is based on the SoftQ RAFT application. SoftQ allows the weld control processor to utilize a series of process analysis algorithms that provide useful information in the state of the welding tool and the quality of the welding process.
| 1. Install / Config / Operation of ViewNet Software |
| 2. Tip (Voltage Sense) Wire Installation |
| 3. Weld Timer Connections |
| 4. Tip Dress Validation |
| 5. Resistance Measure |
| 6. Reference Weld |
| 7. Spot History |
| 8. Expulsion Detection Using Resistance |
| 9. Process Integrity (PI) Envelope |
| 10. Tooling Integrity (TI) Envelope |
| 11. Nugget Integrity (NI) Envelope |
| 12. SoftQ Monitoring Setup |
| 13. Quality Tab |
| 14. Fault Configuration |
| 15. Troubleshooting |
- Teacher: TST Moodle Admin